Description
Photo to laser engraving file: image to Gcode, SVG or BMP at an exact size.
Laser Engrave prepares a photo for a diode laser engraver. Open a picture, tell it what you are burning on and how big, and it gives you a file the machine can run.
A laser cannot print gray. Each spot is burned or left alone, so a photo has to become a field of tiny dots before it goes to the machine, and those dots must match the line spacing of the laser. When that step is skipped, faces come out as dark smudges and a 10 cm coaster comes out 7 cm wide. Laser Engrave handles the conversion and lets you see the result on the color of the real material first.
PICK THE SURFACE
Light wood, bamboo, dark wood, cork, leather, card, slate, anodized aluminium and painted tile. Choosing one sets sensible tone, style and a starting power and speed for a 5 to 20 W diode laser. Slate, aluminium and tile burn light on dark, so the picture is inverted for you.
PICK THE LOOK
Jarvis, Stucki, Floyd Steinberg and Atkinson dithering for photos. Ordered crosshatch, halftone dots, pure black and white for logos and text, sketch outlines that burn fast, and grayscale where the power follows the tone.
SET THE SIZE
Width in millimeters or inches, with the height kept in proportion. Line spacing from 5 to 15 lines per mm (127 to 381 DPI). Circle and rounded corner shapes for coasters, keyrings and tags. Rotate, and mirror the picture for glass or the back of clear acrylic. Brightness, contrast, gamma and invert when a photo needs help.
SEND IT TO THE LASER
PNG that carries its size, so laser software places it at exactly the width you chose.
G-code for GRBL controllers, the kind inside most hobby engravers. Runs from a memory card or USB stick, or through any sender. Rows burn in both directions with overscan, empty rows are skipped, dynamic power keeps corners even, the origin can sit at the bottom left or the center, and S max can be 1000 or 255.
SVG at real size for design software.
BMP for older machine software.
The burn time is estimated before you start.
OPEN SVG AND G-CODE TOO
SVG logos and line art from design apps open like a photo, at the size written in the file.
Tap a .gcode, .nc, .gc or .ngc file in your file manager, or open it from the home screen. The app draws what it will burn on the material, with its real size, burn time, highest power, speeds and line gap, and plays the job back line by line. Handy for checking a file someone sent you before it goes on the machine.
PRO
A power and speed test card: one G-code burns a grid of squares at five powers and five speeds, so you can read off the best setting for a new material in a single run. Pro also removes ads. Every style, material, size and file type works without paying.
SAFETY
Test on an offcut of the same material before the real piece, since every machine and every board burns a little differently. Stay with the laser while it runs, keep the room ventilated and wear eye protection rated for your laser.